SoundID Reference Measurement Microphone
without Software
€89.00
Product description
An omnidirectional measurement microphone with an individual calibration profile. Every microphone has been measured by Sonarworks acousticians against an ANSI-certified measurement microphone. This means perfect accuracy within the audible range and freedom from sample-to-sample irregularities.
Every user can download a 21-day trial for SoundID Reference for Speakers & Headphones. Enjoy unlimited functionality and finally hear how your speakers really sound!
Microphone specification
- Microphone type: electret-condenser
- Transducer type: MEMS
- Frequency response: 20 Hz to 20 kHz
- Polar pattern: omni-directional
- Output impedance: 300 Ω
- Sensitivity: 14 mV/Pa
- Signal-to-noise ratio: 65 dB (A)
- Dynamic range: 106 dB
- Maximum sound level: 124 dB SPL
- Power requirements: +48V phantom power
- Connector type: 3-pin XLR
- Weight: 64 g
- Microphone clip diameter: 21 mm
What's included
- SoundID Reference Measurement Microphone
- SoundID Reference Microphone Clip
- Individual multi-angle calibration profiles for 0°, 30°, and 90° off-axis measurements, incl. TXT format for third-party use
System requirements for SoundID Reference compatibility
- Valid license for SoundID Reference for Speakers and Headphones, or SoundID Reference for Multichannel
- macOS 11 Big Sur, 12 Monterey, 13 Ventura, 14 Sonoma
- Windows 10, 11
- Stable internet connection (offline use not supported)
- 2.0 stereo speaker system (with or without subwoofer), or a supported 2.1-9.1.6 multichannel speaker system (see supported formats here)
- XLR to XLR audio cable
- Microphone stand for multichannel system measurements
- Audio interface requirements during the speaker measurement process:
- +48v Phantom Power support
- The same audio interface must be used for input/output
- The audio interface must support and be set to one of the following sample rate formats: 44.1kHz, 48kHz, 88kHz, 96kHz, 192kHz
- The audio hardware setup must consist of a single external hardware device only (additional preamp units are supported)